Publicité
Les langues disponibles
Les langues disponibles
STEP 1
CHECK DOOR BALANCE
CAUTION
Opening the door will cause the
dishwasher to tip forward when it
is not fully installed. When opening
the door prior to the dishwasher
being fully installed, hold the top of
the dishwasher securely with one hand and hold the
door with the other hand. Gloves should be worn.
NOTE: If installing a custom door panel (available on
some models), follow the instructions found in the
custom door panel kit WD02X25799.
• To check the
door balance,
hold the top of
the dishwasher
firmly.
Increase
• Check the door
balance by
opening and
Decrease
closing the door.
• If the door drops
when released,
increase the
spring tension.
If the door rises
when released, decrease the spring tension.
STEP 2 ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location
and lay it on its back. NOTE: Do not place the
dishwasher on its side.
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/2" less than installation height.
Adjust to
Installation
Height
Dishwasher Installation
Leveling leg
shown with the
dishwasher laying
on its back
STEP 3
REMOVE TOEKICK
• Remove the 4 toekick screws
and the 2-piece toekick. Set
aside for use in Step 19.
STEP 4 INSTALL POWER CORD
Skip this step if the dishwasher will be permanently
connected to the house electrical system or has a
factory-installed power cord.
• The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances. Maximum power cord length is
6 feet. Power Cord Kit WX09X70910 or WX09X70911,
available for purchase from an authorized Monogram
appliances dealer, meets these requirements.
Junction Box
Cover
Dishwasher
Ground Wire
and Screw
Dishwasher
Wires
Dishwasher Ground
Wire and Screw
• Remove junction box cover.
• Install strain relief in the junction box bracket.
• Insert the power cord through the strain relief and tighten.
• Make sure black, white and green dishwasher wires are
threaded through the hole in the junction box bracket.
• Connect power cord white (or ribbed) to dishwasher
white, black (or smooth) to dishwasher black and
ground to dishwasher green wire. Use UL-listed wire
nuts of appropriate size.
• Replace junction box cover using the screw. Be sure
wires are not pinched under the cover.
7
UL Listed Wire Nuts
Black
White
Ground/
Green
Junction Box Bracket
Strain
Relief on
Power
Cord
Publicité
