Publicité
Les langues disponibles
Les langues disponibles
STEP 11
POSITION DISHWASHER
UNDER COUNTERTOP
(CONT.)
Door
Fits and
Swings
Back
Behind
Cabinet
Frame
Correct
Alignment
The controls on these
models are designed
to be hidden by your
countertop. Align the
dishwasher as shown in
figure.
Leave a 1/2" minimum gap
between the underside of the
countertop and the top of the
dishwasher door as shown in
figure.
NOTE: If the drain hose
gets trapped behind the unit
it can prevent the controls
from being hidden by the
countertop.
Tip: The leveling legs can
be used to increase or
decrease the amount of gap
between the controls and
the countertop affecting the
visibility of the controls.
IMPORTANT– Leave a 1/2"
minimum gap between the
controls and the underside
of the countertop to prevent
condensation and damage
to the control panel from
screwheads.
NOTE: If this dishwasher is replacing an existing
dishwasher, the old countertop bracket screw holes
may not be in the correct position to accept a top-
control model. New holes may be required.
Dishwasher Installation
Door Catches
on Cabinet Frame
Incorrect
Alignment
TOP VIEW
Hold 3 Sec To Cancel
Clean
Sanitized
Start
Controls Hidden by Countertop
Countertop
1/2"
Front
Min.
View
Dishwasher
Door
Countertop
Control
Panel
CONNECT WATER
STEP 12
SUPPLY
Connect water supply line to 90° elbow.
If using a flexible braided hose connection:
• Attach nut to 90° elbow using an adjustable wrench.
If using a copper
tubing connection:
• Slide compression nut,
then ferrule over end
of water line.
• Insert water line into
90° elbow.
• Slide ferrule against
elbow and secure with compression nut.
CONNECT POWER SUPPLY
STEP 13
If a power cord with plug is already installed
proceed to Step 14.
WARNING
If house wiring is not 2-wire with ground, a ground
must be provided by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
• Remove junction box cover.
• Secure house wiring to the back of the junction box
with a strain relief.
• Locate the 3 dishwasher wires, (white, black and
green) with the stripped ends coming out of the AC
jumper. Use UL listed wire nuts of appropriate size to
connect incoming ground to green, white to white and
black to black.
• Replace the junction box cover using the screw.
Check to be sure that wires are not pinched under
the cover.
• If using a Power Cord Kit, use Monogram part
number WX09X70910 or WX09X70911 and refer to
the included instructions.
NOTE: Do not remove the Junction Box Bracket.
Junction Box
Cover
Dishwasher
Ground Wire
and Screw
Dishwasher
Wires
Dishwasher Ground
Wire and Screw
NOTE: All ground screws, brackets and wires must
remain intact.
11
90° Elbow
Ferrule
Compression
Nut
UL Listed Wire Nuts
Black
White
Ground/
Green
Junction Box Bracket
Hot Water
Supply Line
House
Wiring
with
Strain
Relief
Publicité
