Technical Data; Threaded Mandrels And Nosepieces Rivet Nuts Per Charge; Safety Instructions; Starting Procedure - Gesipa FireBird Mode D'emploi

2.3. Technical Data

Weight:
Max. stroke:
Operating voltage:
Traction power:
Noise emission:
Vibrations:
2.4. Threaded Mandrels and Nosepieces
Rivet Nuts per Charge
Blind rivet Material Rivet nuts
nut inner
thread
M3 Alu
Steel
M4 Alu
Steel
M5 Alu
Steel
M6 Alu
Steel
M8 Alu
Steel
M10 Alu

2.5. Safety instructions

Blind rivet nut setting tool FireBird
Caution :
Following safety rules must be followed
for adequate protection against electrical shock,
injuries or fire hazards:
•
The tool should be used exclusively to set blind
rivet nuts.
•
Do not overload the tool; Work within the pre-
scribed work capacity.
•
Do not expose the tool to humidity or rain, do
not operate the tool close to inflammable sub-
stances or gases. Risk of explosion!
•
Ensure that the battery is properly secured in
the tool handgrip.
•
Remove the battery when the tool is not in use
and for repair/servicing operations.
•
Do not use the tool as a hammer.
•
When not in use, keep the tool in a dry closed
room, out of reach of children.
2,3 kg (with battery, without
accessories container)
5,5 mm
12 V DC
14.500 N
L
76,5 dB
PA
< 2,5 m/s 2
Part number
per Threaded Nosepiece
charge Mandrel
600 7262019 7262086
550 7262663 7262698
520 7262027 7262094
480 7262574 7262620
480 7262035 7262108
400 7262582 7262639
400 7262043 7262116
300 7262590 7262647
340 7262051 7262124
180 7262604 7262124
300 7262078 7262132
®
•
When working with the tool, always carry pro-
tection goggles. Personal protection like clothes,
gloves, safety helmet, non slipping shoes, ear
protectors and protection against fall are highly
recommended.
•
The air inlets for the engine should not be ob-
structed. Do not introduce anything into them.
•
When depositing the tool, make sure that it
cannot fall down.
•
Use only genuine spare parts for repair.
•
Repair work must be carried out by skilled per-
sonal. In case of doubt, always send back the
tool to the manufacturer.

2.6. Starting Procedure

Before starting read and follow operating
manual carefully!
2.6.1. Adjustment of threaded
x
mandrel length
– By turning the nosepiece 2 adjust the threaded
mandrel length x to the blind rivet nut length.
– In case of closed end rivet nuts (drawing 2; 4)
use full length of thread.
– Lock nosepiece 2 with lock nut 3 against shifting.
2.6.2. Adjustment of stroke
– The stroke y depends on the blind rivet unit size
(M3 – M10) and the grip range z (drawing 4).
Recommended value for stroke y:
Stroke y (in mm)
Thread
size min
M3 1
M4 1
M5 1,5
M6 2,5
M8 2,5
M10 3
– The stroke y is adjusted by screwing in or out
the adjustment nut 4.

(drawing 2)

y
(drawing 2)
max
2
2
2,5
3,5
3,5
4
11