IPC 505 Manuel D'instructions page 18

2.3 - PREPARING THE ENGINE FOR OPERATION
Check the level of the oil in the engine. Fill the fuel tank
with UNLEADED PETROL. Make sure switch pos. 9
Fig. 5 located on the engine, is turned to OFF, otherwise
3.1 - CONTROLS
1) Side brush control lever: switch the lever to ON and the side brush
will move to work position and start spinning. To stop the brush,
switch the lever to OFF.
2) Key switch: this switch starts and stops all the machine's functions.
3) Battery charger socket (on the electric version only): by plugging
a 12 V 10A battery charger in this socket you will recharge the
battery (see the section on battery recharging).
4) Charge indicator light (on the electric version only): this light
indicates the state of the battery during operation.
5) Accelerator lever (on the engine version only): operate this lever
to regulate the speed of the machine.
GB
6
1
6
8
7
ENGLISH (Translation of original instructions)
you will not be able to operate the key pos. 2 Fig. 3 on the
dashboard. For more detailed information on the engine
consult the relevant manual.
4
2
1
2
1
6) Traction lever: by pressing this lever, the machine will start moving
forwards.
7) Filter shaker lever: this lever operates the filter shaker to clean the
filter (see the section on filter maintenance).
8) Knob to operate the air suction inlet (located under the cover):
this opens or closes the suction valve.
9) Timer (on the electric version only): it points out the total amount
of the work hours of the machine (Optional).
10) Filtershacker button (Optional).
11) Suction switch.
9
505 ET
705 ET
10/11 3
505 ST
705 ST
5
Fig. 3