Specifications; Troubleshooting - Toto TLT10 Manuel D'installation Et D'utilisation

Water Supply Pressure
Water Supply Connection
Ambient Temperature
Humidity
Recommended temperature
range (hot supply)
Recommended temperature
range (cold supply)
Temperature Adjustment Range at outlet
Minimum Flow
Problem
The stop valve is turned off.
Water supply is suspended.
Water won't
begin running.
The strainer or the regulating screen
is clogged.
The stop valve is not fully opened.
Low flow rate. The strainer or the regulating screen
is clogged.
The temperature control handle is
Water tempe-
set at "H".
rature is too
The stop valve connected to the
high.
cold-water supply is not fully opened.
The temperature control han dle is
set at "C".
Water temp-
The stop valve connected to the
erature is too
hot water supply is not fully op ened.
low.
The hot water supply temperature is
lower than 120°F.
One side of the stop valve is not fully
Water tempe-
opened.
rature is not
controlled pr-
The strainer or the regulating screen
operly.
is clogged.
SPECIFICATIONS
Minimum required water pressure: 15 psi
Maximum water pressure: 80 psi (551 kPa)
@30 psi (206 kPa), Cold ambient temperature,

TROUBLESHOOTING

Cause
6
(100 kPa) (Flowing)
G1/2 compatible with ½ NPSM
32~104°F (0~40°C)
Max. 90% RH
120 ~ 180°F (49 ~ 82°C)
39 ~ 80°F (4 ~ 27°C)
Ambient temperature ~ 110°F (43.3°C)
(Factory setting 100±4°F (38±2°C)
Hot 176°F (80°C))
0.5gpm (2L/min)
Turn on the valve.
Wait until the water supply is
restored.
Clean the strainer and the regulating
screen.
Open the stop valve fully.
Clean the strainer and the regulating
screen.
Set the temperature control handle to
the middle point.
Open the cold-water stop valve fully.
Set the temperature control
handle to the middle point.
Open the hot water stop valve fully.
Set the hot water supply
temperature to 120°F.
Open the stop valve fully.
Clean the strainer and the regulating
screen.
Solution