Murray EQ2-700X Mode D'emploi page 27

User manual and warranty card
TROUBLESHOOTING
Problem
The device does not
start.
Engine fires unevenly.
Engine fires unevenly.
Excessive vibration.
The mower does not
throw grass in the bin.
Wheel drive not
working (drive
version).
WARRANTY AND SERVICE
The product purchased by you is intended for amateur (hobby) use only. If the equipment is used for
other purposes (commercial, professional), it will lose the guarantor's liability for the purchased
equipment. You can find information on the warranty and the MURRAY service network in the
attached warranty card.
Possible cause
Low fuel.
Spark plug flooded or damaged.
Interruption in ignition system or
contaminated fuel system.
Contaminated air filter.
Low quality fuel.
Clogged fuel line, no fuel or old fuel.
Water, oil or dirt in the fuel system.
Oil flooded carburettor after tilting the
mower to the side.
Badly adjusted brake cable.
Dirty air filter.
Muffler flooded with oil after tilting the
mower to the side.
Knife adapter damaged.
Crooked motor shaft (after impact).
Loose assembly of components.
The grass is too high.
Wet grass.
Inverted or worn cutting knife.
Dirty lawn mower chassis.
A dirty or overfilled basket.
Engine speed too low.
Worn or damaged drive belt.
Cut grass lying down.
Incorrectly adjusted drive cable.
Adjust the drive cable.
Check the fuel level and add fuel if
necessary.
Check, clean or replace the spark plug.
Have the gardening equipment service
repaired, it is best to entrust the mower
to an authorized MURRAY service center.
Replace or clean the filter.
Remove fuel and refuel the mower with
high-quality fuel.
Clean the fuel line, check fuel delivery,
add fresh fuel.
Drain the carburettor with the fuel sink
screw and top up with fresh mixture.
Clean the carburettor from oil.
Make the appropriate adjustment.
Replace the filter.
Top up oil and start the mower for 15
minutes, the oil will burn itself.
Replace it.
Stop the engine immediately and remove
the spark plug cap. Tighten all screws and
make other appropriate repairs. If the
vibration does not disappear, entrust the
repair to an authorized service center.
Mow twice.
Do not mow.
Insert the cutting knife correctly or
replace it.
Clean the mower chassis.
Empty and clean the basket.
Adjust the turnover at the authorized
service center.
Replace the wheel drive belt.
Clean the transmission mechanism.
Adjust the drive cable.
Replace the gear.
27
English
Solution