Murray EQ2-700X Mode D'emploi page 20

User manual and warranty card

Fasten the starter rope handle 5 (Fig. 2) at the attachment point 6 (Fig. 2).
Attention! The starter rope extends with resistance. Pull the engine brake lever towards
you and slowly pull the cable out to the necessary length. Remember that pulling the starter cord
vigorously can start the mower.
FILLING THE ENGINE WITH OIL
The engine is not filled with oil at the factory. There may be traces of oil remnants in the engine after
factory inspection. Before first start-up, pour approximately 0.6L of recommended B&S SAE30 engine
oil (Fig. 6A), checking its level on the dipstick integrated with the oil filler cap (Fig. 6B).
The oil level must be between the lines: min. / max.
Original engine oil for B&S SAE30 for lawn mowers is recommended.
The first oil change should be carried out after 5 hours of mower operation, after burning about two
fuel tanks. The next oil changes should be carried out every 25 hours of work, but at least once
a year.
Drain the used oil while the engine is still hot.
Regularly check the oil level before each use.
If necessary, top up oil.
Attention! Used oil should not be disposed of by accident, dispose of it in the sewage
system or directly into the environment. Take it to an oil disposal point.
REFUELING
 Before using, familiarize yourself with the safety, use, handling and storage principles contained
in this Operation Manual.
 Fuel should be poured outside, in a place where there is no risk of sparks or flames.
 Gasoline should only be stored in suitable containers (canisters) that are approved. Check the
condition of fuel storage containers regularly.
 Fuel tanks must be securely closed. For safety reasons, replace damaged fuel filler caps.
 Do not use beverage bottles or similar to store consumables, e.g. fuel or oil, as other people,
especially children, could drink from them.
 The fuel tank should only be filled outdoors; do not smoke while refueling.
 Gasoline should be topped up before starting the internal combustion engine.
 Do not unscrew the fuel tank cap or add fuel while the internal combustion engine is running or
when the engine is hot.
 Do not overfill the fuel tank! Due to the thermal expansion of the fuel, do not fill the tank above
the lower edge of the filler neck.
 The device must not be stored with the fuel tank filled indoors. The resulting gasoline vapors may
come into contact with open flames and ignite. If the fuel tank needs to be emptied, it should be
done outdoors. Before starting the machine, make sure that there is no spilled fuel on or near the
machine. If necessary, wipe off the fuel.
Attention! Gasoline vapors are flammable. Before starting the mower, make sure that the
working machine is not less than 3m from fuel tanks.
20
English