mundoclima MUCOR-H11T Manuel D'installation Et L'utilisauter page 56

1. CONTROL PANEL
The display panel on the indoor unit can be used to operate the unit in cases when the remote
control has been misplaced or is out of batteries.
1
2
3
Operation buttons
MODE button: Press this button to select the appropriate operating mode. Each time the button
1
is pressed, the operation mode is shifted in the direction of the arrow:
Mode indicators light up to signal the following mode settings.
Auto: Automatically chooses the operation mode by sensing the di erence between the actual
ambient room temperature and the set temperature on the remote controller. The fan speed is
automatically controlled.
Cool: Enables you to enjoy the cooling e ect at you preferred setting temperature (Temperature
range:17°C~30°C).
Dry: Enables you to set the desired temperature at medium fan speed which provides you with
the dehumidi ed surroundings (Temperature range: 17°C~30°C). In Dry mode, you cannot select
Fan speed and Sleep mode.
Heat: Permits heating operation (Temperature setting range:17°C~30°C).
Fan only: Permits fan operation without cooling or heating. In this case, however, the setting
temperature is not displayed and you cannot adjust the set temperature.
Room Temp/Set
Temp/Set Timer
display
Fan speed
operation
display
4
6
5
AUTO COOL DRY
Auto operation
Cooling operation
Dry operation
Heating operation
Fan operation
Vertical air ow
Horizontal air ow
Avoid direct
When wireless control feature
is activated (not avalaible)
Electric heating function (not avalaible)
Lock operation
HEAT FAN ONLY
56