Publicité
Les langues disponibles
Les langues disponibles
3. Remove the Pipe Clip before connecting the pipes and wiring;
fix it again after finishing connection.
Markings
ratproof board
Pipe/wire-hole positions on both sides
Refrigerant/drain
Pipe holeφ67
Pipe/wire-hole position on the bottom
Refrigerant/drain
φ 57.4
Pipe hole
2.
OUTDOOR UNIT INSTALLATION
2.1
Precautions for selecting the location
1) Choose a place solid enough to bear the weight and vibration of
the unit, where the operation noise will not be amplified.
2) Choose a location where the hot air discharged from the unit or
the operation noise will not cause a nuisance to the neighbours
of the user.
3) Avoid places near a bedroom and the like, so that the operation
noise will cause no trouble.
4) There must be sufficient spaces for carrying the unit into and out
of the site.
5) There must be sufficient space for air passage and no
obstructions around the air inlet and the air outlet.
6) The site must be free from the possibility of flammable gas
leakage in a nearby place.
7) Install units, power cords and inter-unit wire at least 3m away from
television and radio sets. This is to prevent interference to images
and sounds. (Noises may be heard even if they are more than 3m
away depending on radio wave conditions.)
8) In coastal areas or other places with salty atmosphere of sulfate
gas, corrosion may shorten the life of the air conditioner.
9) Since drain flows out of the outdoor unit, do not place under the
unit anything which must be kept away from moisture.
NOTE:
Cannot be installed hanging from ceiling or stacked.
Then attach the ratproof
board into the hole
First remove the metal
Pipe/wire-hole position on back side
Refrigerant/drain
φ67
Pipe hole
When operating the air conditioner in a low outdoor ambient
temperature, be sure to follow the instructions described below.
- To prevent exposure to wind, install the outdoor unit with its suction
side facing the wall.
- Never install the outdoor unit at a site where the suction side may
be exposed directly to wind.
- To prevent exposure to wind, it is recommended to install a baffle
plate on the air discharge side of the outdoor unit.
- In heavy snowfall areas, select an installation site where the snow
will not affect the unit.
2.2
Figure of body size
MODEL
W
MUER-48-H11T-E
952
48
CAUTION
- Construct a large canopy.
- Construct a pedestal.
Install the unit high enough off the
ground to prevent burying in snow.
D
H
W1
A
415
1333
1045
634
Unit:mm
B
404
Publicité
