Publicité
Les langues disponibles
Les langues disponibles
Removing the grille
1
Loosen, then remove the finishing screws from the
four corners on the front of the grille.
2
After detaching the grille, remove the fastening
screws from the four holes on the front of the speaker.
Optionally, you can insert the supplied caps into the holes.
• Do not use a screwdriver (or hex wrench) to tighten the
screws. Overtightening could damage the speaker.
• When not in use, store the screws with these operating
instructions for safekeeping.
Magnetic shielding
This speaker system is magnetically shielded. However,
depending on the installation location, color distortion may
occur if the speaker system is installed extremely close to the
screen of a television set.
If this happens, turn off the television, then turn it on again
after 15 min to 30 min. If the problem persists, place the
speaker system away from the television set.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient
to keep the cabinet clean. If necessary, clean with a cloth
dipped in a neutral cleanser diluted five or six times with
water, and wrung out well. Do not use furniture wax or
cleansers.
Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit since these will corrode the
surfaces.
Specifications
Enclosure ......................................... Bass-reflex bookshelf type
Configuration ...................................................................... 3-way
Woofer .............................................. 18 cm (7
Tweeter ........ 14 cm (5
Nominal impedance ............................................................. 6 Ω
Frequency response ........................................ 34 Hz to 100 kHz
Sensitivity ........................................................... 89.5 dB (2.83 V)
Maximum input power ..................................................... 200 W
Exterior dimensions
................................. 820 (W) mm × 291 (H) mm × 425 (D) mm
Weight ................................................................... 39 kg / 86 lbs.
Supplied accessories
Speaker base .................................................................... ×1
Speaker spikes (with attached nuts) .............................. ×4
Spike bases ...................................................................... ×4
Fastening screws (for grille) ............................................ ×4
Finishing screws (for grille) ............................................. ×4
Caps ................................................................................ ×10
Grille .................................................................................. ×1
Operating instructions .................................................... ×1
• Specifications and design subject to possible modifica-
tion without notice, due to improvements.
• Real, natural wood is used in the construction of the
speaker system cabinets. They feature a wonderful color
and depth that is much more attractive than plastic
veneers and similar materials.
No two pieces of natural wood are exactly alike. Keep
this point in mind as you enjoy these speakers.
Get other manuals https://www.bkmanuals.com
(magnetically shielded)
1
/
16
1
/
inch) cone / 3.5 cm (1
2
5
7
32
/
(W) in. x 11
/
(H) in. x 16
16
16
With the cooperation of AIR Studios, this
speaker has been designated AIR Studios
Monitor Reference.
is a trademark placed on a product with
Pioneer's Phase Control technology.
This technology enables high-grade sound
reproduction through each component by
improving overall phase matching.
inch) cone ×2
3
/
inch) dome
8
3
/
(D) in.
4
5
En
Publicité
