Télécharger Imprimer la page

Flex CHE 4-32 SDS-plus Notice D'instruction D'origine page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
CHE 4-32 SDS-plus
2. Insert the drill bit.
3. Swivel the auxiliary handle into
the required position.
4. Insert the mains plug.
5. Grip the power tool with both hands and
assume the working position.
6. Position the drill bit and switch on the
power tool.
7. Gently press the power tool forwards.
8. After drilling, switch off the power tool.
9. Pull out the mains plug.
Chiselling
1. Insert the chisel.
2. Move the operating mode rotary knob to
the
symbol.
3. Turn the chisel into the required
position.
4. Move the operating mode rotary knob to
the
symbol. Make sure it audibly clicks
into place.
5. Swivel the auxiliary handle into
the required position.
6. Insert the mains plug.
7. Grip the power tool with both hands and
assume the working position.
8. Switch on the power tool.
9. When chiselling, gently press the power
tool forwards to prevent it from jumping.
10. After working, switch off the power tool.
11. Pull out the mains plug.
Other information
– The use of "sharp" cutting accessories
increases performance and the service
life of the power tool.
– After work, clean the power tool and
store in the carrying case in a dry
location.
Maintenance and care
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use. Regularly blow out the housing interior
and motor with dry compressed air.
Carbon brushes
The power tool is equipped with cut-off
carbon brushes.
When the cut-off carbon brushes reach their
wear limit, the power tool switches off
automatically.
NOTE!
Use only original parts supplied by
the manufacturer for replacement
purposes. The use of non-original parts or
makes will invalidate any claims under the
manufacturer's warranty.
When the power tool is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes are sparking
excessively, switch off the power tool
immediately. Take your power tool to
a customer service centre authorised by
the manufacturer.
Gears
NOTE!
Do not loosen the screws on the gear head
during the warranty period. Failure to
comply with this requirement will invalidate
any claims under the manufacturer's
warranty.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
If the power cord of the power tool is
damaged, it must be replaced with
a specially prepared power cord
(attachment type X). This power cord is
available from FLEX customer service.
Spare parts and accessories
Other accessories, in particular cutting
accessories, can be found in the
manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
17

Publicité

loading