Télécharger Imprimer la page

Flex CHE 4-32 SDS-plus Notice D'instruction D'origine page 16

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
 Screw the three-jaw chuck onto the
adapter (1.).
 Insert the adapter (2.) and turn (3.) until it
locks.
 Check the lock by pulling on the three-
jaw chuck.
Setting the operating mode
CAUTION!
Do not change the operating mode until
the power tool has come to a stop.
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
Setting the chisel position (see
below)
Chiselling
NOTE!
– The rotary knob must audibly click into
place in all positions.
– Do not switch on the power tool in the
position (setting the chisel position).
16
Setting the chisel position
The chisel can be turned to a position which
is ideal for the work to be performed.
 Move the operating mode rotary knob to
the
symbol (1.).
 Turn the chisel until it is at the required
angle (2.).
 Move the operating mode rotary knob to
the
symbol (3.). Make sure it audibly
clicks into place.
Switching on the power tool
 Press and hold down the trigger switch.
The power tool trigger switch enables
the speed or impact rate to be increased
slowly to the maximum value.
To switch off the machine:
 Release the trigger switch.
Operating instructions
Drilling/hammer drilling
1. Move the operating mode rotary knob to
the
(drilling) or
symbol. Make sure it audibly clicks into
place.
CHE 4-32 SDS-plus
(hammer drilling)

Publicité

loading