Télécharger Imprimer la page

Flex CHE 4-32 SDS-plus Notice D'instruction D'origine page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
CHE 4-32 SDS-plus
 Swivel the auxiliary handle into the
desired position (2.).
 Secure the adjustment by turning the
auxiliary handle clockwise.
Attaching the depth stop
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
 Release the clamping by turning the
auxiliary handle counterclockwise (1.).
 Push in the depth stop (2.).
 Set depth stop to the required drilling
depth.
 Secure the adjustment by turning the
auxiliary handle clockwise.
Inserting tools with SDS shank
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS shank.
If tools do not have an SDS shank
(e.g. wood drill bit), a three-jaw chuck must
be used (see "Fitting the three-jaw chuck").
 Check the dust cap.
– Clean the cap if dirty.
– Have a defective dust cap replaced.
 Clean tools and lightly grease the shank.
 Insert the cutting accessory (1.) and turn
(2.) until it locks.
 Check lock by pulling on the cutting
accessory.
Removing the accessories
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
 Pull the locking sleeve backwards (1.).
 Remove the cutting accessory (2.).
Fitting the three-jaw chuck
NOTE!
To fit a three-jaw chuck you will need the
original adapter from the FLEX accessories
range.
15

Publicité

loading