Pioneer DMH-WT86NEX Manuel D'installation page 12

Installing the
microphone
• Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
• Be sure to turn off (ACC OFF) the product
before connecting the microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
Mounting on the sun visor
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Attach the microphone clip to the sun
visor.
12
En
Microphone clip
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot
recognize the driver's voice if the sun
visor is in the down position.
Installation on the steering
column
1
Detach the microphone base from the
microphone clip by sliding the
microphone base while pressing the
tab.
Tab
Microphone base
2
Mount the microphone on the
steering column.
Double-sided tape
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
NOTE
Install the microphone on the steering
column, keeping it away from the steering
wheel.
Adjusting the microphone angle
The microphone angle can be adjusted.
The adjusting position
and mounting
dimension of the
display
▶DMH-WT8600NEX/DMH-
WT7600NEX/DMH-WT86NEX/DMH-
WT76NEX
The mounting position of this unit's display
can be adjusted (front-back/up-down/
right-left/angle). When mounting the
display, adjust the mounting position and
dimensions so that your view is clear and it
does not impair your driving.
WARNING
Make sure that none of the following
conditions exist when mounting the
display. Otherwise, an accident may occur.
• It impairs the operation of the steering
wheel and levers (shift lever, windshield
wiper switch, turn signal switch, etc.).
• It impairs the operation of the airbags.
• It significantly impairs the operation of
the hazard switch.
• It impairs the ability to identify or operate
other control switches.
• You are unable to see gauges, meters or
warning indicators.
• It interferes with in-vehicle devices
(switches, panel, glove compartment, cup
holder, etc.).
Depending on the vehicle, the display may
hinder access to the glove compartment or
cup holder, or it may block the air
conditioner vents.