Publicité
Les langues disponibles
Les langues disponibles
TIP
The amount of this unit's protrusion from
the dashboard/console can be adjusted by
shifting the position of the screw hole of
this unit to the factory radio-mounting
bracket.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
Installing the GPS
antenna
CAUTION
Do not cut the GPS antenna lead to
shorten it or use an extension to make it
longer. Altering the antenna cable could
result in a short circuit or malfunction and
permanent damage to this product.
Installation notes
• The antenna should be installed on a
level surface where radio waves will be
blocked as little as possible. Radio waves
cannot be received by the antenna if
reception from the satellite is blocked.
Dashboard
Rear shelf
• When installing the GPS antenna inside
the vehicle, be sure to use the metal
sheet provided with your system. If this is
not used, the reception sensitivity will be
poor.
• Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS antenna.
• Take care not to pull the antenna lead
when removing the GPS antenna. The
lead may become detached.
• Do not paint the GPS antenna, as this
may affect its performance.
When installing the antenna inside the vehicle (on the dashboard or
rear shelf)
WARNING
Do not install the GPS antenna over any sensors or vents on the dashboard of the vehicle, as
doing so may interfere with the proper functioning of such sensors or vents and may
compromise the ability of the metal sheet under the GPS antenna to properly and securely
affix to the dashboard.
GPS antenna
Metal sheet
Peel off the protective sheet on the rear.
Double-sided tape
Clamps
Use clamps to secure the lead where necessary inside the vehicle.
NOTES
• Affix the metal sheet on the surface as level as possible where the GPS antenna faces the
window.
• Affix the GPS antenna on the metal sheet using the double-sided tape.
• The metal sheet contains a strong adhesive which may leave a mark on the surface if it is
removed.
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass
through. On such models, install the GPS antenna on the outside of the vehicle.
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.
11
En
Publicité
