Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Insert the front spill guard feet into the slots in the rear spill
guard. The rear flange will rest on the burner box.
A
B
A. Front spill guard
B. Feet and slots
4. Place burner assembly over spill guard, making sure burner's
rear flange is seated in slot.
5. Check the surface burner and grill flames. Refer to the
"Complete Installation" section.
6. Install the wave tray into the grill. The tab in the left rear
corner of the bay must fit through the slot in the left rear
corner of the wave tray.
A
A. Slot for locating tab
B. Locating tab
7. Place the wave plate on the wave tray. The wave plate must
be centered on the wave tray.
8. Replace grill grate.
The griddle is factory installed.
1. Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops.
B
2. Clean and season griddle before using. Refer to the Use and
Care Guide that came with your cooktop.
3. Check the surface burner and griddle flames. Refer to the
"Complete Installation" section.
A
A. Wave tray
B. Wave plate
Install Griddle
(on some models)
A
B
A. Griddle drip tray
B. Griddle
B
11
Publicité
Table des Matières
