Publicité
Les langues disponibles
Les langues disponibles
EN
7.2
The tool does not operate when the deadman's handle is operated
/i
Possible cause
The battery condition is poor.
The tool is not started.
The battery pack is in the sleep mode. This
occurs when the tool is not used for about
10 minutes.
The electric motor does not operate.
The temperature indicator of the tool
flashes.
The temperature indicator of the battery
flashes.
The internal sensors of the tool are dirty.
7.3
The LEDs of the tool do not come on when the tool is started
/i
Possible cause
The battery pack is not locked.
The battery pack is in the sleep mode. This
occurs when tool is not used for about 10
minutes.
The deadman's handle is not in neutral
position.
7.4
The useful operating time between the individual charging cycles of the
battery pack is less than 5 minutes
/i
Possible cause
The battery pack is worn out.
7.5
The deadman's handle is jammed or doesn't return automatically to the
neutral position
/i
Possible cause
The deadman's handle is damaged
externally.
The deadman's handle is faulty.
7.6
The cutting is poor
/i
Possible cause
The blades are damaged.
48
All manuals and user guides at all-guides.com
Clean the sensors. Refer to 6.4.4
916.400.096_003
Solution
•
Check the battery pack condition. See section 3.6.2.
•
Replace the battery pack by a fully charged battery
pack.
Push the on/off switch. The LEDs should come on.
To start the battery pack again:
•
Push the on/off switch.
Have it repaired by a Holmatro Certified Technician.
Refer to 3.4.
Refer to 3.4.
Solution
Remove the battery pack and put it in the tool again until
the battery pack locks.
To start the battery pack again:
•
Push the on/off switch.
Put deadman's handle in neutral position.
Solution
Replace the battery pack.
Solution
Have it repaired by a Holmatro Certified Technician.
Have it repaired by a Holmatro Certified Technician.
Solution
Sharpen or file the cutting edge of the blades in the
correct shape.
PCU50
Publicité
