Vortice ME Serie Livret D'instructions page 42

ENGLISH
NB: when the supply voltage is applied the appliance starts up in "Test Mode" for a time of approximately 1 min 30 sec.
In the first 30 seconds of operation in "Test Mode" the signal supplied by the PIR module is ignored and the motor runs
at the speed set with the jumper. In the remaining 60 seconds the motor will only start after a signal from the PIR module,
at the speed set with the jumper; when there is no signal from the PIR module, the motor will stop immediately (time lag
for switching off = 0). At the end of the "Test Mode" phase, the appliance will go into normal operation.
Table B
Speed Jumper
Position A Position B
V1 MIN speed MAX speed
Wiring diagrams
Fig. 21 ÷ 24
When using the wiring diagram in Figure 22 b, the humidity control cannot be disabled (models ME 100/4" LL TP HCS,
ME 120/5" LL TP HCS); you need to set the "Timer" operating mode (switch 6 = OFF in "DIP-switch" Table).
Maintenance and cleaning
Fig. 25 ÷ 27
Important information concerning the environmentally compatible disposal
This product complies with Directive 2012/19/EU on the management of waste electrical and electronic equipment
(WEEE).
The crossed-out wheeled bin symbol on the appliance indicates that, at the end of its life, the product
should not be discarded together with household waste but must be taken to a separate collection point
for electrical and electronic equipment. This will avoid negative effects on the environment and health, and
will encourage correct treatment, disposal and recycling of the materials from which the product is made.
Contact the municipal authority for the location of this type of facility. Alternatively, the distributor is obliged to take back
the appliance to be disposed of free of charge in exchange for the purchase of an equivalent appliance.
42