Inventum IKI9035MAT Mode D'emploi page 26

BUILDING - IN THE HOB
• Check that the kitchen unit and the opening conform to the requirements in respect of measurements and ventilation.
• Remove any wood shavings after the cutting work in the worktop opening and treat the cut edges of plastic or wooden
worktops with sealing varnish if necessary to prevent the worktop from swelling due to moisture.
• Lay the hob upside down on the worktop.
• Mount the plug to the connecting cable in accordance with the imposed requirements.
• Mount the supplied fastening brackets using the supplied screws in the induction hob.
• Turn the hob over and lay it in the opening.
• Adjust the bracket position to suit for different table top thickness.
Warning: Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation
(see picture).
• Connect the hob to the mains supply. The hob is now ready for use.
• Check the operation. If the induction hob is connected incorrectly, it will give a sound signal or show an error code
on the displays.
REMOVING THE HOB
Disconnect the appliance from the power supply. Remove the induction hob by applying pressure from below. Attention!
Take care not to damage the appliance! Do not try to remove the induction hob by trying to lift it out of the worktop
from above.
26 • English
fastening bracket
fastening bracket
hob
work top