Inventum IKI3020 Mode D'emploi page 29

Les langues disponibles

THE FITTING OF THE APPLIANCE

• Check that the cabinet and the cut-out meet the dimension and ventilation requirements.

• Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic

worktops with sealing varnish if necessary, to prevent moisture causing the worktop to swell.

• Lay the hob upside down on the worktop.

• Fit the connecting cable to the appliance in compliance with requirements.

• Remove the protective layer from the sealing tape and apply the tape on the edge of the glass plate. Make sure to apply

the tape to the glass and not on the metal part. Do not stick the tape around the corners, but cut 4 separate pieces to

seal the corners well. Attention: any damage that occurs when not applying the tape has concequences for the warranty.

• Fit the supllied mounting brackets on the appliance.

• Turn the hob over and lay it in the recess.

• Connect the appliance to the mains. The appliance is ready for use.

• Check that it works properly. If the appliance has been wrongly connected either a bleep will sound or an error code will

appear on the displays.

REMOVING THE HOB

Disconnect the hob from the mains. Remove the hob by pushing it upwards from the bottom. Attention! Beware of damage

to the appliance! Do not try to remove it from the top.

problems & solutions

If there is an error, an error code will be shown at the displays.

Error code

Cause

Cooling fan is disabled.

Supply voltage is too high.

Supply frequency is different from the rated values

(50Hz).

The hob is overheated.

Control defect.

Coil temperature sensor is defect.

Cooler temperature sensor is defect.

Calibration error.

Solution

Contact the service department of Inventum.

Have the installation checked by a qualified electricien.

Switch the appliance off and let the cooking zones cool down.

Contact the service department of Inventum.

English

•