Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION DIMENSIONS
In the drawings below, all the dimenions are displayed in mm.
* 60 mm when using a wooden back.
** 150 mm when using a wooden sidewall.
VENTILATION
The electronics in the hob need to cool. The hob will automatically switch off if there is insufficient air circulation and the
hob will overheat. There are ventilation openings on the underside of the appliance. It must be possible for cool air to be
drawn in through these openings. There are outlet openings to the front of the appliance.
Ventilation occurs through the plinth and the back of the cupboard. Saw out the ventilation openings (min. 100cm
Air supply through the plinth is superflous if, together with an opening at the back of the cupboard, there's an opening
somewhere else through which air can be drawn in.
Ensure that there is sufficient air circulation.
• Make a ventilation opening to the front of the kitchen unit at least the width of the hob and to a minimum height of 5 mm if
the hob is built-in above a drawer or plank.
• Ensure there is a minimum height of 10 mm between the oven, the drawer or separator and the hob.
Metal objects can become hot because of the ventilation. If this occurs, we advise to use a separator. This can be a
wooden panel.
• Attention: when fitting the hob above an oven the thickness of the worktop must be at least 35 mm and above a drawer
the thickness of the worktop must be at least 20 mm.
• Ensure the crossbar does not impede the airflow. Plane or saw the crossbar [C] diagonally if necessary.
Fitting above an oven - A
Fitting above a drawer - B
).
2
27
English
•
Publicité
