Télécharger Imprimer la page

Husqvarna 550 XP Mark II Guide D'utilisation page 13

Masquer les pouces Voir aussi pour 550 XP Mark II:

Publicité

Les langues disponibles

Les langues disponibles

brake is too sensitive, it can engage during rough
operation.
Will the chain brake always protect me from injury
during a kickback?
No. The chain brake must operate correctly to give
protection. The chain brake must also be engaged
during a kickback to stop the saw chain. If you are
near the guide bar, it is possible that the chain brake
does not have time to stop the saw chain before it
hits you.
WARNING: Only you and the correct
working technique can prevent kickbacks.
To start the product
To prepare to start with a cold engine
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
(B)
To start the product on page 13 for
4. Continue to
more instructions.
To prepare start with a warm engine
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
544 - 005 - 10.05.2019
(A)
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
4. Press down the start/stop switch (C) to set start
throttle setting.
(A)
To start the product on page 13 for
5. Continue to
more instructions.
To start the product
WARNING: You must keep your feet in a
stable position when you start the product.
WARNING: If the saw chain rotates at idle
speed, speak to your servicing dealer and
do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING: Do not twist the starter rope
around your hand.
(B)
(C)
13

Publicité

loading

Ce manuel est également adapté pour:

545g mark ii545 mark ii550 xp g mark ii