Agri-Fab 45-0326 Notice D'utilisation page 6

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
If your tractor hitch has 10" to 13" ground clearance
refer to figure 4. If your tractor hitch has 8" to 10"
ground clearance refer to figure 5.
5. (Figure 4 or 5) Assemble the hitch brackets to the
hitch tubes using two 5/16" x 2-1/4" hex bolts (B)
and 5/16" hex lock nuts (G). The bolts should straddle
the front hitch tube bolt. Do not tighten yet.
6. At this time tighten the four bolts fastening the hitch
tubes to the sweeper housing. Next, tighten the two
bolts fastening the ends of the hitch tubes together.
Finally, tighten the two bolts fastening the hitch
brackets to the hitch tubes.
7. (Figure 4 or 5) Assemble the hitch pin (Y), two 3/4"
spacers (U) and the 1/8" hair cotter pin (N) to the hitch
brackets.
5/16" HEX
LOCK NUT (G)
5/16" HEX
LOCK NUT (G)
ENGLISH
4
5/16" x 2-1/4"
HEX BOLT (B)
HITCH PIN (Y)
HITCH BRACKET
3/4" SPACER (U)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (N)
5
5/16" x 2-1/4"
HEX BOLT (B)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
3/4" SPACER (U)
HITCH BRACKET
1/8" HAIR
COTTER PIN (N)
www.mymowerparts.com
8. (Figure 6) Assemble the height adjustment handle to
the height adjustment tube as shown in figure six.
Use two curved head bolts (C), bowed washers (L),
5/16" lock washers (K) and 5/16" hex nuts (H). Do not
tighten yet.
9. (Figure 6) Assemble the grip onto the height adjust-
ment handle.
5/16" HEX NUT (H)
5/16" LOCK
WASHER (K)
BOWED
WASHER (L)
CURVED
HEAD BOLT (C)
10. (Figure 7) Insert a 5/16" x 3/4" hex bolt (F) through the
angle bracket. Assemble onto the bolt (in order) the
spacer bushing (T), the height adjustment strap, a 5/16"
flat washer (J) and a 5/16" hex lock nut (G). Tighten.
5/16" x 3/4"
HEX BOLT (F)
HEIGHT
ADJUSTMENT
STRAP
6
6
GRIP
HEIGHT
ADJUSTMENT
HANDLE
7
5/16" FLAT
WASHER (J)
SPACER
BUSHING (T)
5/16" HEX
LOCK NUT (G)