Vermeiren V100 XL Mode D'emploi page 16

To transport the wheelchair in the car use following steps:
1. Remove footrests and accessories.
2. Store footrests and accessories safely.
3. If possible, fold the wheelchair and remove the wheels.
4. Place the wheelchair in the luggage place.
5. If the wheelchair and the passenger compartment is NOT separated, attach the
frame of the wheelchair securely to the vehicle. You can use the available safety
belts in the vehicle.
3 Installation and adjustment
The instructions in this chapter are for the specialist dealer.
The Vermeiren V100 XL has been designed to be adjust with a minimum of replacements
parts. There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING:
Risk of unsafe settings - Use only the settings described in this
   
manual.
WARNING:
Variation of allowed adjustments can still change the stability of your
   
wheelchair (tilt back or sideways).
3.1 Tools
To set up the wheelchair the following tools are needed.
Wrench set n° 7 to n° 22
•
Allen key set n° 3 to n° 8
•
Screwdriver n° 4 to n° 5
•
Screwdriver Phillips head
•
3.2 Manner of delivery
The Vermeiren V100 XL shall be delivered with:
1 frame with arm supports, rear and front wheels (seat height of 500 mm)
•
1 pair footrests
•
Tools
•
Manual
•
Accessories
•
3.3 Adjusting the seat height
The Vermeiren V100 XL is adjustable in 3 seat heights by changing the wheels position. At
each height there is a different setting of the front and rear wheels.
WARNING:
The top hole of the axle plate is not intended for mounting the rear
   
axle - This hole is for mounting the drum brake.
Seat height
470 mm
500 mm
(Standard)
530 mm
Rear wheel
Hole 1 Both bushings above the castor stem housing
Hole 2 One bushings above, and one under the
castor stem housing
Hole 3 Both bushings under the castor stem housing
Table 2: Seat heights
ƒ‰‡
V100 XL
Front wheel
2012-02