PANCONTROL PAN 118 Manuel page 28

All manuals and user guides at all-guides.com
8. Operating Instructions

Please refer to the sketches on the first pages of this manual.

Always switch OFF the device when it is not in use.
Point Illumination (Flashlight)
In low light conditions, you can illuminate the point. To do this, press the
button (5.2).
Backlight
To turn the backlight on or off, press for two seconds the button (5.2).
Data hold
If the reading could not be read during measurement due to difficult
operation the „HOLD"-button (5.3) could be pressed to freeze the display
reading.
1. Press the „HOLD"-button to freeze the display reading.
2. The display shows the „HOLD"-symbol to indicate the activated HOLD
function.
3. Press the „HOLD"-button again to return to standard operation.
Auto power off
If no further measurements are carried out, the device switches off
automatically after 10 minutes.
Voltage measurement (AC / DC)

Set the rotary switch to the position V

With the function key FUNC (5.1) you switch between AC and DC.

Touch the measuring points with the probe tips.

Once the reading stabilizes, read the value.

DC: If the polarity is reversed a "Minus sign" is displayed.
Current masurement (AC / DC)

Set the rotary switch to the position mA

With the function key FUNC (5.1) you switch between AC and DC.

Switch off the power source and open the circuit to be tested at the
position you are going to measure the current.
or µA
EN 11