Thermador PALPKITHW Instructions D'installation page 9

Installation procedure
NOTE: All graphics are representative. Appearances may
vary.
Disassembling the rangetop
⚠
CAUTION
Before proceeding with the conversion, shut off the gas
supply to the appliance prior to disconnecting the
electrical power.
Disconnect the appliance from electrical power by
unplugging the electrical cord from its receptacle or by
disconnecting power at the circuit breaker box.
To disassemble the rangetop
1. Remove the rangetop grates and the burner caps.
2. To facilitate the removal of the spill tray, remove the T-
20 star-head screws in the front face of the island trim
or backguard.
3. Use a 16 mm hex head bit for burners labeled 'D' or
'F'. Use a 9 mm hex head bit for burners labeled 'B' to
remove the burner venturi from each burner base.
a. Hex head bit
TIP: If a 16 mm hex head bit is not readily available, a 5/8''
hex bit can be selected. Alternatively, a bolt with 5/8''
head either "double-nutted" or tightened into the chuck
of a power driver can be used.
a
2
1
b. Burner venturi
4. Disconnect the igniter. Carefully pull up on the burner
base.
a
b
c
d
e
f
g
h
i
j
5. Remove the screw securing the burner pedestal with a
T-30 star-head driver. Carefully remove each burner
pedestal.
6. Remove the spill trays by pivoting the trays up and out
the back.
7. Remove the heat shield on some models. Some
models have a double-width shield that extends under
adjacent spill tray.
Converting the regulator to LP
The gas regulator is located in the rangetop, left side of
appliance. Exact location will vary per model.
1. Remove the
conversion cap with
b
a 7/8'' socket or
wrench, or an
adjustable wrench.
a. Grate
b. Burner cap
c. Venturi
d. Burner base
e. Electrode
f. Burner pedestal
g. Spill tray
h. Heat shield
i. Igniter housing
j. Igniter wire
9