Thermador PALPKITHW Instructions D'installation page 11

2. Label each of the removed orifices, noting from which
burner they were removed, in the event the appliance
is converted back to natural gas in the future.
Burner layout legend
For your convenience, note the orifice sizes and
locations in the following table.
Left rear
Left front
3. Locate the proper STAR
orifices included with the kit.
Orifices are stamped with the
orifice diameter size on the side.
4. Replace orifices as indicated in the tables beginning
on page 11 . Ensure the orifice is completely seated
and tight to the jet holder to avoid possible gas leaks.
NOTE: All of the replacement orifices in the conversion kit
have straight threads (not pipe threads) and do not
require thread sealing compound.
Changing "B" STAR® burners (305
models only) and/or "D" and "F"
STAR® burners
This procedure can be applied when:
• Converting size "B" burners.
• Preferred by the installer to change orifices of any size
burner ("B", "D", or "F").
• A 7 mm or 9/32'' socket, or ¼'' nut driver is not
available for use when changing the orifices on "D"
and "F" burners.
To replace the "B" STAR® burner orifices (or any burner
size orifice)
1. From the side of the jet holder, insert a 9/32'' open
end wrench into the space between the metal wire
and the jet holder. Remove the gas orifice from the
STAR burner's jet holder.
a
b
Left center rear
Left front center
®
burner
a. Jet holder
b. Metal wire
c. Gas orifice
c
Center rear Right center rear
Center front Right center front
2. Label each of the removed orifices, noting from which
burner they were removed, in the event the appliance
is converted back to natural gas in the future.
3. Locate the proper STAR burner
orifices included with the kit.
Orifices are stamped with the
orifice diameter size on the side.
4. Replace orifices as indicated in the tables beginning
on page 11 . Ensure the orifice is completely seated
and tight to the jet holder to avoid possible gas leaks.
NOTE: All the replacement orifices in the conversion kit
have straight threads (not pipe threads) and do not
require thread sealing compound.
Pro Harmony ranges and Pro
Rangetops propane (LP) STAR® burner
orifice conversion kits
PALPKITHW
PALKITHW5
PALPKITHA5
PALPKITGA
PALPKITGA6
Right front
For Pro Harmony dual fuel ranges and
Pro Rangetops with 4 and 6 STAR®
burners
For Pro Harmony dual fuel ranges and
Pro Rangetops with 5 STAR® burners
For Pro Harmony gas ranges with 5
STAR® burners
For Pro Harmony 30'' and 36'' gas
ranges with 4 and 6 STAR® burners
For Pro Harmony 48'' gas ranges with 4
and 6 STAR® burners
Right rear
11