Grohe EUROECO COSMOPOLITAN E 36 269 Instructions D'installation page 5

All manuals and user guides at all-guides.com
GB
Safety notes
Prevent danger resulting from damaged voltage
supply cables.
If damaged, the voltage supply cable must be
replaced by the manufacturer or his customer service
department or an equally qualified person.
• Installation is only possible in frost-free rooms.
• The plug-in voltage supply is only suitable for indoor use.
• The plug-in connectors must not be directly or indirectly
sprayed with water when cleaning.
• The voltage supply must be separately switchable.
• Use only genuine replacement parts and accessories.
The use of other parts will result in voiding of the warranty
and the CE identification, and could lead to injuries.
Technical data
Fitting with switched-mode power supply:
• Voltage supply: 100-240 V AC 50-60 Hz/6.75 V DC
• Power consumption:
Fitting with battery:
• Voltage supply: 6V lithium battery type CR-P2
• Automatic safety shut-off:
(6 - 420 s adjustable)
• Run-on time (0 - 19 s adjustable):
• Reception range according to Kodak Gray Card,
grey side, 8x10", landscape (7 - 20cm adjustable):
• Type of fitting protection:
Thermal disinfection possible.
Electrical test data
• Software class
• Contamination class
• Rated surge voltage
• Temperature of ball impact test
Fault / Cause / Remedy
Fault Cause
Water not flowing • Filter upstream of solenoid valve blocked
• Solenoid valve defective
• Plug-in connector without contact
• No voltage
- Battery discharged
(indicator lamp lights up continuously)
- Power supply unit defective
Undesired water • Sensor system detection zone set too high
flow for local conditions
• Automatic flushing activated
• Solenoid valve defective
Flow rate too low • Mousseur dirty
• Filter upstream of solenoid valve dirty
The test for electromagnetic compatibility (interference emission
test) was performed at the rated voltage and rated current.
If static pressures exceed 0.5 MPa, a pressure-reducing valve
must be installed.
Functions, programme selection,
see technical product information,
www.grohe.com/tpi/euroeco-ce
GROHE Deutschland Vertriebs GmbH
Zur Porta 9
D-32457 Porta Westfalica
Installation
, see fold-out page I - II.
Flush pipes thoroughly before and after
installation (observe EN 806)!
2.4 W
Open hot and cold water supply and check that
connections are watertight.
Maintenance
, see fold-out page II.
60 s
•Shut off water supply.
•Disconnect voltage supply.
1 s
•Inspect and clean all components and replace if
necessary.
12cm
IP 59K Replacement parts
see fold-out page I (* = special accessories)
A
,
2
Care
2500 V
For directions on the care of this fitting, please refer to the
100 °C
accompanying Care Instructions.
Remedy
- Clean or replace filter
- Replace solenoid valve
- Check plug-in connector
- Replace battery
- Replace power supply unit
- Reduce range using remote control (special
accessory, prod. no.: 36 407)
- Wait 1 - 10 minutes
- Replace solenoid valve
- Clean or replace mousseur
- Clean filter
2