Kärcher T-Racer T 400 Plus Mode D'emploi page 7

General information
Please read and comply with
these original instructions prior
to the initial operation of your appliance and
store them for later use or subsequent own-
ers.
Proper use
The T-Racer can used with all Kärcher
Consumer high-pressure cleaners; prefera-
bly with appliances of classes K4 to K7.
You will need an additional adapter for ap-
pliances manufactured before 1991 (order
no. 4.762-062).
The T-Racer is ideally suited for the clean-
ing of floor and wall surfaces made of differ-
ent materials, such as wood, plastic,
concrete, tiles, and natural stone, as well as
for cleaning Japanese gardens and peb-
bled surfaces. Use the T-Racer exclusively
in your private household.
Symbols
Danger!
Do not hold under the edge of the
T-Racer when it is on!
Environmental protection
The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for
disposal, but arrange for the proper
recycling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of old
appliances. Please dispose your old
appliances using appropriate collec-
tion systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
Safety instructions
 Please observe the safety instructions
of your high-pressure cleaner.
 Only trigger the high-pressure jet at the
high-pressure gun if the T-Racer is lo-
cated on the surface to be cleaned.
 There must be no persons in the imme-
diate vicinity of the cleaning head.
 Beware of the recoil force! Ensure a
stable position and firmly hold the high-
pressure gun with the extension tube or
the handle.
 Switch off the high-pressure cleaner
when you finish cleaning. If you are us-
ing the T-Racer then disconnect the
same from the high-pressure gun.
 Maximum water temperature 60 °C
(please observe the instructions of your
high-pressure cleaner).
– 4
EN
Warranty
Spare parts
7