Publicité
Les langues disponibles
Les langues disponibles
Additional information
Problem
No sound from subwoofer.
The PHASE CONTROL
feature doesn't seem to have
an audible effect.
Noise during playback of a
cassette deck.
No sound is output or a noise
is output when software with
DTS is played back.
During a playback search,
noise is output from a DTS
compatible CD player.
Can't operate the remote
control.
The display is dark or off.
Resetting the main unit
Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the TONE button,
press and hold the STANDBY/ON button
for about three seconds.
Remedy
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it's turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 28 to YES
or PLUS.
• Switch the LFE Attenuator Setup on page 31 to
LFEATT 10
.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see Speaker Distance on page 30).
• Move the cassette deck further from your receiver, until the noise
disappears.
• Set the digital volume level of the player to full, or to the neutral
position.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 5).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front
panel (refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
3
display, press the ENTER button.
OK? shows in the display.
4
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
When you see RESET? appear in the
Press SETUP to confirm.
LFEATT 0
or
09
35
En
Publicité
