How the Cycle Works
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring,
loss of gloss, hairline cracks and
popping sounds.
Before self-cleaning, make sure the door is completely closed or
the door will not lock and the self-cleaning cycle will not begin.
Once the oven has completely
cooled, remove ash with a damp
cloth. To avoid breaking the glass, do not apply a cool damp cloth
to the inner door glass before it has completely
cooled.
To stop the self-cleaning cycle at anytime, press the Cancel button
on the keypad. If the temperature is too high, the oven door will
remain locked and "cool" and "locked" will be displayed. The
cooling fan may continue to run.
Once the cleaning temperature has been reached, the electronic
control requires a 12-hour delay before another self-clean cycle
can be started.
The oven light will not function during the self-cleaning cycle.
Electronic
Oven Control
with Adjustable
Self-Clean
(HI-
LO)
The self-cleaning
cycle can be set at HI self-clean time (4 hours
30 minutes) or LO self-clean time (3 hours 30 minutes). The
suggested clean times are 3 hours 30 minutes for light soil, or
4 hours 30 minutes for heavy soil. The last 30 minutes of the
cycles is for cool down.
2.
3.
To Self-Clean:
1. Press SELF CLEAN to set the clean time to HI (4 hours
30 minutes).
Press the TEMP/TIME "+" or "-" arrow pads to cycle between
LO and HI clean time.
4=
5.
Press START.
The oven door will automatically
lock. The CLEAN indicator
light will be displayed. The time remaining will also be
displayed.
When the self-clean cycle is complete and the oven cools, the
CLEAN indicator light will turn off.
When the oven is completely cooled, remove ash with a damp
cloth.
Genera
C eaning
IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Always follow label instructions on
cleaning products. For additional information, you can visit the
Frequently Asked Questions (FAQs) section of our website at
www.amana.com.
In Canada, reference the Customer Service
section at www.amanacanada.ca.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
EXTERIOR PORCELAIN
ENAMEL SURFACES
(on some models)
Food spills containing acids, such as vinegar and tomato, should be
cleaned as soon as the entire range is cool. These spills may affect
the finish.
Cleaning Method:
•
Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad:
Gently clean around the model and serial number plate
because scrubbing may remove numbers.
•
affresh ® Kitchen and Appliance Cleaner Part Number
W10355010 (not included):
See cover for contact information.
STAINLESS
STEEL (on some models)
NOTE: To avoid damage to stainless steel surfaces, do not use
soap-filled scouring pads, abrasive cleaners, Cooktop Cleaner,
steel-wool pads, gritty washcloths
or abrasive paper towels.
Damage may occur to stainless steel surfaces, even with one-time
or limited use.
Cleaning Method:
Rub in direction of grain to avoid damaging.
•
affresh ®Stainless Steel Cleaner Part Number W10355016 (not
included):
See cover for contact information.
PORCELAIN-COATED
GRATES AND CAPS
Food spills containing acids, such as vinegar and tomato, should be
cleaned as soon as the cooktop, grates and caps are cool. These
spills may affect the finish.
To avoid chipping, do not bang grates and caps against each other or
hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Do not clean in the Self-Cleaning cycle.
Cleaning
Method:
•
Nonabrasive plastic scrubbing pad and mildly abrasive
cleanser:
Clean as soon as cooktop, grates and caps are cool.
•
Dishwasher (grates only, not caps):
Use the most aggressive cycle. Cooked-on soils should be
soaked or scrubbed before going into a dishwasher.
•
Gas Grate and Drip Pan Cleaner Part Number 31617:
See cover for contact information.
SURFACE BURNERS
•
See"Sealed Surface Burners" section.
COOKTOP
CONTROLS
To avoid damage to the cooktop controls, do not use steel wool,
abrasive cleansers or oven cleaner.
To avoid damage, do not soak knobs. When replacing knobs, make
sure knobs are in the OFF position.
On some models, do not remove seals under knobs.
Cleaning Method:
•
Soap and water:
Pull knobs straight away from control panel to remove.
Liquid detergent or all-purpose
cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
METALLIC PAINT (on some models)
Do not use abrasive cleaners, cleaners with bleach, rust removers,
ammonia or sodium hydroxide (lye) because paint surface may stain.
CONTROL PANEL AND OVEN DOOR EXTERIOR
To avoid damage to the control panel, do not use abrasive cleaners,
steel-wool pads, gritty washcloths or abrasive paper towels.
Cleaning Method:
•
Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on panel.
•
affresh ®Kitchen and Appliance Cleaner Part Number W10355010
(not included):
See cover for contact information.