Télécharger Imprimer la page

Electrolux EUF27393X Notice D'utilisation page 43

Masquer les pouces Voir aussi pour EUF27393X:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
Problem
The temperature in the
freezer is too high.
The appliance does not
operate.
A large quantity of drops
ice covers the top com-
partment inside the appli-
ance. .
As much as the advice does not lead to result, call the nearest brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Cleaning the evaporator
1. Switch off the appliance.
2. Disconnect the mains plug from the
mains socket.
3. Remove all foods from the freezer and
put them in a fresh place.
4. Move the appliance far from the wall.
5. Leave the door open.
6. After approximately 20 minutes the
drain hose at the rear of the cabinet
starts to discharge water into the drip
tray.
7. To prevent the water overflowing from
the drip tray dry with a sponge.
All manuals and user guides at all-guides.com
Possible cause
The food temperature is too high. Let the food temperature de-
Food is too near to each other.
Large quantities of food to be fro-
zen were put in at the same time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The door has been open to long. Close the door.
There is too much frost and ice
on the evaporator of the appli-
ance, the door was open for too
long time.
crease to room temperature be-
fore storage.
Store food so that there is cold air
circulation.
Insert smaller quantities of food to
be frozen at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Cleaning the evaporator".
8. The defrosting process ends when the
water stops dripping. It may take sever-
al hours if the problem started long be-
fore.
9. Move the appliance to the original posi-
tion.
10. Clean and dry the inside of the appli-
ance.
11. Connect the mains plug into the mains
socket.
12. Switch on the appliance.
electrolux 43
Solution

Publicité

loading

Ce manuel est également adapté pour:

Euf27391w5