Husqvarna 525iLK+TAB850 Manuel D'utilisation page 12

3. Push the shaft into the coupling until it clicks into
position.
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
12
4. Pull the attachment out of the coupling.
C
To install the harness support hook
1. Install the harness support hook between the loop
handle and the throttle handle.
Note:
Do not put the support hook on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the harness support hook.
3. Adjust the length of the harness until the harness
support hook is in level with your right hip.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
on page 19 .
Use protective gloves.
Always use the cutting
Technical data
1938 - 003 - 24.02.2023