Husqvarna 525iLK+TAB850 Manuel D'utilisation page 13

WARNING:
cutting attachment can result in injury or
death.
To attach the cutting attachment guard
1. Attach the cutting attachment guard (A) to the hook
on the plate holder (B).
B
A
2. Install the cutting attachment guard on the shaft and
tighten it with the bolt (C).
To remove the cutting attachment
guard
• Loosen the bolt (C) and remove the cutting
attachment guard (A) from the shaft.
A
Introduction
WARNING:
safety chapter before you use the product.
1938 - 003 - 24.02.2023
An incorrectly attached
C
C
Operation
Read and understand the
Assembly of trimmer heads
WARNING:
cutting attachment it is very important that
the raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING:
attachment without an approved guard. See
the chapter on Technical data. If an incorrect
or faulty guard, or the J-handle is missing
when using metallic cutting attachment, is
fitted this can cause serious personal injury.
To attach a trimmer head
1. Put the drive disc (B) on the output shaft.
2. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Turn the trimmer head (A) counterclockwise to
attach.
A
B
C
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
When you install the
Never use a cutting
Only use Husqvarna
13