Oregon Scientific BAR623P Mode D'emploi page 15

RESET SYSTEM
The RESET button is located in the main unit battery
compartment. Press RESET when you change the
batteries and whenever performance is not behaving as
expected (for example, unable to establish radio
frequency link with remote sensor or clock).
PROJECTION UNIT
The projection unit can display both time and outdoor
temperature. To use this feature:
• Press the SNOOZE / LIGHT button to project
the time and outdoor temperature for 8 seconds.
OR
• Slide the PROJECTION switch to ON to activate
continuous projection. However, this function will
not work unless the AC / DC adaptor is used.
P/N:086L003564-068 REV1
15/146
BAR623P_EN_R4.p65
All manuals and user guides at all-guides.com
14
14
You can also:
• Adjust the FOCUS knob to make the image
clearer.
• Adjust the IMAGE ROTATION knob to rotate the
image clockwise or anti-clockwise.
• Manually tilt the projection unit to position the
image vertically upwards or downwards.
SAFETY AND CARE
Clean the product with a slightly damp cloth and alcohol-
free, mild detergent. Avoid dropping the product or
placing it in a high-traffic location.
WARNINGS
This product is designed to give you years of service if
handled properly. Oregon Scientific will not be
responsible for any deviations in the usage of the device
from those specified in the user instructions or any
unapproved alterations or repairs of the product. Observe
the following guidelines:
8/7/04, 2:28 PM