Publicité
Les langues disponibles
Les langues disponibles
□ Installation Procedures
Note:
Disconnect the cable from the negative (—) battery terminal.
1. Secure Mounting Collar ©.
Insert Mounting Collar © into the dashboard, and bend the mounting tabs out with a screwdriver.
a) Check the electrical connections by referring to this operating instructions. (• Page 33)
b) Connect Mounting Bolt (
5
), using a suitable wrench.
c) Insert Power Connector (6) to the unit.
d) Insert the unit into the Mounting Collar © and push it in until a "click" is heard.
■ Using Rear Support Strap @
Affix one end of Rear Support Strap © to the rear of the unit, and the other end to the fire wall of the
car, or some other metallic area.
■ Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the fire wall of the car.)
Cover the Mounting Bolt (
5
) on the rear of the unit with the Rubber Cushion (Optional), and mount it
into the existing Rear Support Bracket.
Fire wall of the car
Rear Support Bracket
29
Publicité
