KitchenAid KGCU407 Instructions D'installation page 15

A
B
C
D
A
B
C
D
5. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into gas opening and press down onto the
gas orifice spud and remove by turning the gas orifice spud
counterclockwise and lifting out. Set gas orifice spud aside.
6. Replace with correct LP gas orifice spud. See the "LP Gas
Orifice Spud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
LP Gas Orifice Spud/Hood Chart
Burner Color Size
Rating
3,000 BTU NA 0.65 mm
12,500 BTU Blue 1.04 mm
15,500 BTU Yellow 0.93 mm
Green 0.55 mm
14,500 BTU Black 1.18 mm
Burner orifice spud
A
A. Size stamp or color
7. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
8. For medium and large burners, replace the burner base using
both screws. Replace burner head and cap.
For small burners, replace igniter using the following
instructions.
Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Burner Style
Small burners
Medium burners
Large burner - main
Large burner - simmer
Grill burner
Grill orifice hood
A
A. Size stamp
Replace Igniter - Small Surface Burners Only
1. Unplug igniter wire from electrode.
IMPORTANT: Do not let the igniter wire fall down under the
cooktop surface.
2. Using needle-nose pliers, remove the retaining clip and
spring from the igniter.
B
A
A. Retaining clip
B. Spring
C. Natural gas igniter
3. Remove Natural gas igniter from burner base.
4. Place spacer ring onto the LP gas igniter and insert into the
burner base.
A
A. Spacer
5. Insert new spring from LP conversion kit onto the underside
of the igniter and lock into place with the new retaining clip.
B
A
A. Retaining clip
B. Spring
C. LP gas igniter
6. Place Natural gas igniter, spring, and clip in plastic parts bag
for future use and keep with package containing literature.
7. Plug in igniter wire.
8. Replace the burner base using both screws.
9. Replace burner head and cap.
To Convert Grill Burner (on some models)
1. Remove grill grate, wave plate, flame spreader and burner
assembly. See "Install Grill Grease Trays" section for removal
instructions. Set parts aside.
C
C
15