Clarity XLC3.4+ Mode D'emploi page 32

TROUBLESHOOTING
• Make sure the charging contacts on the handset and base are free of dust and dirt.
While unplugged, clean the contacts with a soft cloth.
• Make sure IN USE / CHARGE light on the base is lit when the handset is in the
cradle.
• If necessary, replace the handset battery.
• Move closer to the base and try again.
• Make sure you have selected the correct dialing mode, tone or pulse.
• Make sure the AC adapter is not plugged into a wall outlet with other appliances.
Disconnect for 5-10 seconds then reconnect. Place the handset back on the base
and reinsert the AC adapter.
• Make sure the handset battery is fully charged.
• Verify that the AC adapter is plugged into the base and into the wall outlet.
• The handset is out of range or the power to the base is unplugged.
• Move closer to the base.
• Place the handset into the base until the screen returns to standby mode. It will
take approximately 5-10 seconds for the handset to register to the base.
• Handset may need to be re-registered to the base manually. Follow instructions on
page 28.
30
All manuals and user guides at all-guides.com