Connection Diagram - Alesis TRANSACTIVE 400 Guide D'utilisation

User Guide (English)
1. Make sure all items listed in the Box Contents are included in
the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING
THE PRODUCT.
3. Study the connection diagram.
4. Make sure all input devices such as microphones, CD players,
and linked amplifiers/PAs are turned off and volume settings
are set at "zero."
5. Switch everything on in the following order.
i. audio input sources (i.e. microphones, instruments, CD Players)
ii. TRANSACTIVE 400
iii. any additional amplifiers
6. When shutting down, always reverse this operation by turning off:
i. any additional amplifiers
ii. TRANSACTIVE 400
iii. audio input sources (i.e. microphones, instruments, CD Players)
Support
For product registration, visit alesis.com.
For the latest information about this product (system requirements, compatibility information, etc.), visit
alesis.com/transactive-400.
For additional product support, visit alesis.com/support.

Connection Diagram

HEADPHONES
Important:
•
With all speakers, an initial "break-in" period is needed to perform at optimal levels. To properly "break-
in" your TRANSACTIVE 400, play an audio source at medium volume for a few hours.
•
For best audio quality, avoid using this device in a high RF-radiated environment.
POWER
CD PLAYER, ETC.
DRUM MODULE
3
Box Contents

TRANSACTIVE 400

Power Cable (standard IEC)

User Guide

Safety & Warranty Manual
Any items shown here but not mentioned in
the Box Contents are sold separately.
(additional TRANSACTIVE 400
MIXER
sold separately)