Faber GALILEO SMART BK F830 + KIT LL H80 Manuel D'utilisation page 3

EN
1. SAFETY
INSTRUCTIONS
For your own safety and
to guarantee proper use
of the appliance, please read
this manual carefully before
installing and using the
product. These instructions
must always be kept with the
appliance, even if it is moved
or sold. Users must be fully
aware of how the appliance
works and of its safety
features.
These hobs have induction
systems that comply with
the requirements of EMC
standards and with the
EMF directive and they
should not interfere with
other electronic devices.
Pacemaker wearers and
those using other electronic
implants must consult their
doctor or the manufacturer
of the implanted device to
assess whether or not it is
sufficiently resistant against
interference.
Electrical connections
must be carried out by
a trained technician.
Before making the
electrical connection,
please read the section
on ELECTRICAL
CONNECTION.
For appliances with a power
supply cable, the terminals or
section of wire between the
cable anchor point and the
terminals must be arranged in
such a way as to allow the live
wires to be pulled out before
the earth wire in the event of
the cable coming out of its
anchor.
The manufacturer will not
•
be liable for any damage
resulting from incorrect or
inadequate installation.
Check that the mains
•
power supply corresponds
to the one indicated on the
identification plate fixed to
the inside of the product.
Fixed electrical connections
•
must incorporate the cut-
out devices envisaged by
current regulations.
For class I appliances,
•
check that the domestic
power supply guarantees
an adequate earthing
system.
Connect the suction
•
hood to the flue using a
suitable pipe. Please refer
to the accessories to be
purchased, indicated in
the installation manual (for
circular pipes: minimum
diameter 120 mm). The
exhaust pipe must be as
short as possible.
Connect the product to the
•
mains using an omnipolar
switch.
The air venting regulations
•
must be complied with.
3