Faber GALILEO SMART BK F830 + KIT LL H80 Manuel D'utilisation page 15

7.4 Fuction hood controls
Timer symbol
After selecting the suction hood Digit, press the Timer Management Digit to set
the countdown.
Grease filter maintenance symbol
The grease filter cleaning signal is displayed by LED
enabled.
Charcoal filter maintenance symbol
The hood is set by default to ducting mode. With no loads on, press the
Hood controls digit to enable the suction hood. Press and hold the Digit
again for 5 seconds to:
Activate the charcoal filter:
The charcoal (odour) filter symbol
Deactivate the charcoal filter:
The charcoal (odour) filter symbol
After activation, the icon will light up to indicate that maintenance must be
carried out on the charcoal (odour) filter
Reset and reactivation of the charcoal filter
After having carried out maintenance on the filter:
• press
the countdown will be started again.
• press
the countdown will be started again.
Press " 9 " on the power bar to set INTENSIVE 1 speed. This setting is
timed to operate for 10 minutes. Once this time has passed, the system
"9"
will automatically return to the speed set previously. It is deactivated by
selecting a different speed.
Press " 9 " on the power bar twice to set INTENSIVE 2 speed. This setting
is timed to operate for 5 minutes. Once this time has passed, the system
will automatically return to the speed set previously. It is deactivated by
selecting a different speed.
This function is only available if Automatic mode is deactivated. Automatic
mode is deactivated by pressing
Delay
Press the suction hood Digit and set a speed on the power bar.
Press the Timer management Digit, which was displaying "CL" but will
change to the countdown. This is pre-set to 15 minutes.
and hold for 5 seconds. - The grease filter LED will go out and
and hold for 5 seconds. - The odour filter LED will go out and
lights up for 1 second.
flashes twice.
.
.
and it is always
15