Napoleon B81NS Instructions D'installation Et D'opération page 3

2.3 BULKHEADS
NOTE: Bulkhead covers need to be removed.
A. Connect the gas fl ex lines and the pilot line
to the gas bulkheads located under the valve
access opening. Be sure to match up the gas
manifold marked with a dot with the center
bulkhead, also marked with a dot. Care must be
taken to ensure the pilot line isn't damaged and
ensuring gas tight connections are made.
NOTE: The middle tube is the primary burner
and cannot be turned off. The outside burner
can be turned on and off with the remote. If
this isn't the case then switch the fl ex lines.
B. Connect the pilot electrode leads to the
bulkhead. The leads can only fi t one way. You
need to match the 1/4" fl ag with the 1/4" bulkhead
spade and the 3/16" fl ag with the 3/16" spade.
C. Ensure the 2 venturi tubes are over the orifi ces
before lighting. NOTE: It is recommended at
this stage to do an operational check before
fi nishing installation.
D. Check for gas leaks by brushing on a soap and
water solution. Do not use open fl ame.
E. After leak test has been performed re-install
access panel with gasket. (If removed)
2.4 NIGHT LIGHT™ INSTALLATION
The HD81-1 comes equipped with two "Night Lights™". The lights have been pre-wired and are controlled
from the remote control.
If in the event the lamps or lens need replacing, follow the instructions below:
A. Shut off breaker at main power supply
B. Remove the four screws that secure the lens frame to the fi rebox sides. This frame retains the glass lens.
C. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special
"high temperature" products. When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. "Light Leakage" from the holes in the housing lamp may be
observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
GASKET
LENS
FRAME
BULKHEADS
PILOT
PILOT
ELECTRODE
ELECTRODE
LEADS
VENTURI
TUBE
ORIFICE
NIGHT LIGHTS
3
PRIMARY
EN
BURNER
DOTS
PILOT
GAS
BULKHEADS
W415-0808 / D / 11.04.16