Maxima 09100000 Manuel D'instructions page 24

ENGLISH (Translated from original language)
6. Take out the filter holder.
 You can run the cleaning program on several groups
at the same time.
 In order to eliminate any unpleasant flavors after the cleaning, prepare a normal coffee.
CLEANING OF THE GRIDS AND TRAYS
Remove the plastic grids of the cup warming area and the metal grids of the tray under the groups.
Remove the tray under the group.
Clean grids and tray with a humid cloth and a bit of specific detergent for coffee machines.
CLEANING OF THE DEPOSIT TANK
After extracting the tray under the groups, you have access to the machine's deposit tank. Clean the
tank and its drain with a brush. Make sure that the drain is not blocked by debris.
CLEANING OF THE MACHINE
Clean the machine's body with a humid soft cloth. Do not use abrasive or solvent detergents.
 Regularly (at least every two weeks) clean the water purifier, following the instructions supplied
with it.
7. Repair
 All repair and maintenance interventions must be carried out by qualified and authorized persons.
 If the power cable is damaged, it must be replaced only by specialized personnel and duly
authorized by the manufacturer.
 Only use original spare parts.
The lower tray is not fixed to the machine's body. Take out the tray in order to get access to the motor,
to the main switch and the flowmeter.
Take off the upper tray in order to get access to the groups, the keyboards and the switches. In DI
models, taking off the upper tray will also give you access to the water tank. In order to take off the
upper tray, unfasten the screw in the center of the upper tray.
8. Alarms (CV models)
8.1. TIME-OUT during water filling
When the water level probe does not detect water in the boiler, the machien automatically starts the
water filling. A volumetric counter controls the time of filling. If the water filling takes more time than
defined (120 seconds), the water filling is automatically interrupted. All LEDs start to blink.
In order to turn off the alarm, switch off the machine and switch it on again.
8.2. TIME-OUT during drink production
A counter controls the duration of the drink production on the portion keys. If the drink production
takes longer than the predefined time (more than 5 seconds), the LED of the active portion key starts to
blink. If the counter does not receive any impulse up to 4 minutes, the production is interrupted. The
LED continues to blink until a new selection is made.
8.3. No water in the water tank (DI models)
The water tank is equipped with water level probe. If the probe does not detect water for more than 3
seconds, the machine is automatically blocked. All LEDs start to blink. Once the water tank has been
filled with water, the machine returns to the normal functioning mode and the LEDs stop to blink.
In case the probe detects a low water level during drink production, the drink production is finished and
only then the LEDs start to blink.
22
Espresso Coffee Machine – Operating Manual
7. Let the group run 2-3 times in
order to rinse it.