Publicité
Les langues disponibles
Les langues disponibles
ENGLISH (Translated from original language)
3.3.
Necessary connections
1 water supply tap for a 3/8 nut (for connection with water supply hose);
1 compatible drain with at least 16/17 mm diameter;
1 earthed electrical outlet;
1 earthed electric supply with a 30 mA protection and a disjuncture of 3 mm between the contacts.
4. Installation and basic adjustments
4.1.
Usage location
Choose a dry location for the coffee machine where it cannot come in direct contact with water.
Do not direct water jets onto the equipment!
Choose a stable and levelled surface to place the machine on.
For a correct installation, that surface the machine is placed on must have a height of at least 800
mm above the floor level.
The machine should not be installed close to inflammable or heat-sensitive materials. If this is not
possible, isolate the space surrounding the machine with a non-inflammable, heat resistant
isolation material.
In places where the temperature can drop below freezing point, leave the machine switched on in
order to avoid that frozen water damages groups and pipes.
Leave enough space next to the machine for the water purifier and a grinder.
In order for a correct functioning of the machine, the ambient temperature must be between 15-
25ºC.
4.2.
Unpacking
Before using the machine for the first time, remove all plastic protections. Make sure the machine is
complete. Dispose safely of the plastic wrapping as they are potentially dangerous. Clean the exterior of
the machine with a soft humid cloth.
4.3.
Setup of water connection
In case the water supply does not have a pressure above 1 bar, use a anti-reflux valve at the entry
of the water supply hose
1.
Place the machine on a stable position on the working surface, ideally in its final working
position.
2.
Place the water filter system in a convenient position and connect the filter system to the
water supply. Connect the machine to the filter system using the water supply hose already installed on
the machine.
MARINA CV DI: MODELS WITH INTERNAL WATER TANK
1.
In order to fill the water tank, take off the lid positioned on the left side of the cup warming
area.
2.
On the lower part of the machine there's a drain water deposit. In case the machine is installed
in a location without access to a fix drain, use this deposit.
4.4.
Electric installation
ONLY CONNECT THE MACHINE TO AN EARTHED ELECTRIC SUPPLY!
To avoid the risk of damage to the machine, make sure that the rating on the data plate
corresponds to the voltage and frequency of the power supply.
Connect the machine to an earthed outlet. Never use multiple plugs or extension cables to
connect the machine
Make sure the mains electric supply has a 30mA protection and a circuit breaker with 3 mm space
between the contacts.
All installation works must strictly comply with current local and national safety regulations.
18
Espresso Coffee Machine – Operating Manual
Publicité
