S?
SBE 41cp CTD
agent menu
T
get or set RTC time
U
attach logstream to
a file
V
close log file
Section 8 General information
8.1 Warranty
8.2 Service and support
18
Show help menu for CTD setup and tests:
?—print menu
Sa—activate CP (continuous profiling) mode
Sb—bin-average CP data
Sc—show calibration coefficients
Sd—deactivate CP mode
Sf—show gateway mode
Sg—enter gateway mode
Sk—configure the SBE 41cp
Sm—measure power consumption
Sn—show serial number
Sp—get pressure
Ss—get pressure, temperature, salinity
St—get pressure and temperature, low power
Su—upload CP data
See or set time programmed in float, mm/dd/yyyy:hh:mm:ss
save all information from display to a file
close a log file started with
This product can expose the user to chemicals with silica, crystalline (airborne particles of
respirable size), which is known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Refer to the manufacturer's website for warranty information (seabird.com/warranty).
Only trained personnel may do the tasks described in this section of the document.
Refer to the website for FAQs and technical notes, or contact the manufacturer for
support at support@seabird.com. Do the steps below to send a sensor back to the
manufacturer.
1. Complete the online Return Merchandise Authorization (RMA) form or contact the
manufacturer.
Note: The manufacturer is not responsible for damage to the sensor during return shipment.
2. Remove all batteries from the sensor, if so equipped.
3. Remove all anti-fouling treatments and devices.
Note: The manufacturer will not accept sensors that have been treated with anti-fouling
compounds for service or repair. This includes AF 24173 devices, tri-butyl tin, marine anti-
fouling paint, ablative coatings, etc.
4. Use the sensor's original ruggedized shipping case to send the sensor back to the
manufacturer.
5. Write the RMA number on the outside of the shipping case and on the packing list.
U
W A R N I N G
N O T I C E