Sea-Bird Scientific NAVIS Mode D'emploi page 18

I? diagnostics menu
K kill (inactivate)
mission
L list mission
parameters
M mission
programming agent
16
?—print menu
a—operate air pump for 2 seconds
b—move to the pressure activation buoyancy position
c—close air valve
d—show buoyancy position
e—increase buoyancy by 4 counts
f—freeze into inactive mode
g—go to a specified position, 1–1023 counts
i—use algorithm to surface to inflate the air bladder
l—set maximum engineering file size, 5–63 kb
m—close the high-pressure valve
n—open high-pressure valve
o—open air valve
r—decrease buoyancy by 4 counts
s—start the SelfTest()
t—calculate ToD downtime expiration
+—increase buoyancy by approximately 0.5 ml
- —decrease buoyancy by approximately 0.5 ml
turn off current mission. Float will start again in pressure-activation mode after
approximately 10–15 minutes
show mission setup parameters
The command to modify the parameters shows to the right of each parameter in the list.
The manufacturer strongly recommends the user use the Navis Mission
Configuration software to change setup parameters. The software verifies that the
configuration is valid.
change mission setup parameters.
M
Enter to start this mode and send selected command.
The command to modify the parameters shows to the right of each parameter in the list.
The manufacturer strongly recommends the user use the Navis Mission
Configuration software to change setup parameters. The software verifies that the
configuration is valid.