Publicité
Les langues disponibles
Les langues disponibles
PART NUMBER: E771SFN100
STEP 6: Reposition part onto rear bumper. Align again following STEP 3 and 4. Ensure each tape liner is positioned properly from STEP 5. Find the "home" position
and inspect both sides of the part to ensure proper positioning then firmly hold in place.
STEP 7: While firmly holding the part with your left hand, use your right hand to gently pull the liner shown below by approximately 3" (76mm) BUT DO NOT PRESS
DOWN.
3" (76mm)
STEP 8: Press down on the part by a finger's width only at the location shown below. Do not press down anywhere else but now lightly hold the part in place.
Only press here.
ISSUE
SUBARU OF AMERICA
PART NUMBER: E771SFN100
10-20-2022
PAGE 4 / 9
01
Publicité
