Subaru E771SFN100 Instructions D'installation page 3

PART NUMBER: E771SFN100
STEP 3: DO NOT REMOVE ANY TAPE AT THIS TIME. Place part on rear bumper and roughly align the rear gate's latch striker with the center triangle on the part. Then
look under the hatch's weather stripping for molded-in triangles in the rear bumper and align with the outboard triangles on the part. See detailed illustration below.
Inspect the gaps on all 4-sides and become familiar with the "home" position of this part.
STEP 4: While part is in the home position locate supplied left and right corner alignment templates. Using the part as a guide position the right then the left
templates. Ensure templates are against back vertical wall and aligned with part profile, then tape down outside edges of templates.
STEP 5: Flip part over. Fold and crease the tape liners as shown in the illustration below. You may tape each liner to the top surface of the part (optional).
ISSUE
SUBARU OF AMERICA
PART NUMBER: E771SFN100 10-20-2022 PAGE 3 / 9
01