Publicité
Les langues disponibles
Les langues disponibles
A
B
TTACHING THE
EATERS
Be sure the speed control dial is in the
OFF position and unplug electric cord
from the electrical outlet.
Lift mixer head up and back to pull it
out of the way of the bowl.
N
: It is important that the beaters
OTE
go into the correct sockets. Otherwise
the mixer will not give you the proper
mixing action. Do not risk ruining a
recipe or damaging your mixer. Read
the following instructions carefully.
One of the beaters is shaped like a cone
and has a nylon button on the bottom.
It goes into the socket on the side of
the mixer nearest the side of the bowl.
The other beater is square-shaped and
goes into the socket nearest the center
of the bowl. See beater symbols located
on the bottom of the mixer head.
C
-S
ONE
HAPED
B
EATER
All manuals and user guides at all-guides.com
Insert the beaters, one at a time,
using a combination pressing and
twisting motion, until the beaters
snap into position.
If a beater should not properly snap
into place, pull it out of the socket
and rotate it one quarter turn.
Reinsert the beater into the socket
until it snaps into position.
A
(Some Models Only)
Set the speed dial in the OFF position
and unplug the electric cord from the
electrical outlet.
Lift mixer head up and back to tilt it out
of the way of the bowl, while holding it
in an upright position.
N
the correct sockets. The mixer will
operate with the dough hooks in the
wrong position. However, you will not
get proper kneading action and you
S
QUARE
could risk ruining a recipe or damaging
B
EATER
your mixer. Read the following
instructions carefully.
N
YLON
B
UTTON
6
S
IDE OF
B
OWL
D
TTACHING THE
OUGH
: The dough hooks must go into
OTE
C
S
ONE
QUARE
B
B
EATER
EATER
H
OOKS
Publicité
