Doro NeoBio 3/5r Mode D'emploi page 9

Remote access
�he unit can be remotely accessed using an ordinary tone dialling telephone.
1. Call the answer machine.
2. Press
when the outgoing message is played.
*
3. Enter the PIN code, see TAM Settings. One beep confirms correct code.
4. Select a remote access command, see below.
5. Replace the handset.
Command Function
2.......................Erase single msg during playback
4.......................Skip to previous message
5.......................Playback of messages
6.......................Skip to next message
7.......................Turn on the answer machine
8.......................Stop
9.......................Turn off the answer machine
Remote activation
�he answer machine can be activated via the remote access functions.
1. Call the answer machine. It will answer after approximately 10 rings.
2. Press when the outgoing message is played.
*
3. Enter the PIN code, see Answer machine Settings. One beep confirms correct code.
4. Press .
7
5. Replace the handset.
Troubleshooting
Check that the telephone cord is undamaged and properly plugged in. Disconnect any additional equipment, extension
cords and other phones. If the problem is resolved, the fault is with some other equipment.
�est the equipment on a known working line (e.g. at a neighbour's house). If the equipment works there the fault is
probably with your telephone line. Please report this to your network operator.
No number shown when ringing
- �his function requires a Caller ID subscription from your service provider.
Warning tone/Not possible to make calls
- �he batteries may be running low (charge the handset).
- �he hand unit may be nearly out of range. Move closer to a base unit.
Telephone does not work
- Check that the adapter/phone cord is connected correctly.
- Check that you have selected �one Dial, see System Settings.
- Check the charge status of the handset batteries.
- Connect another functioning telephone to the network wall socket.
The telephone continues to ring
- Some of the telephone's ringers do not follow the line signal, which means that the signal may continue for up to 8
seconds after answering a call.
All manuals and user guides at all-guides.com
English